MT−46
MANUAL TRANSMISSION (RA60)
INSPECTION
1.
Using a cylinder gauge, measure the inside diameter of the out-
put shaft.
D14079
If the diameter exceeds the maximum, replace the output shaft.
2.
(a)
If the clearance is less than the minimum, replace the synchro-
nizer ring.
D13974
(b)
D13975
−
OUTPUT SHAFT
INSPECT OUTPUT SHAFT
Standard inside diameter:
45.009 to 45.025 mm (1.7720 to 1.7726 in.)
Maximum inside diameter:
45.025 mm (1.7726 in.)
INSPECT SYNCHRONIZER RING
Using a feeler gauge, measure the clearance between
the synchronizer ring and the gear spline.
Standard clearance:
0.70 to 1.50 mm (0.0276 to 0.0591 in.)
Minimum clearance:
0.70 mm (0.0276 in.)
Coat the output shaft and synchronizer ring cone with
gear oil. Check the braking effect of the synchronizer ring.
Turn the synchronizer ring in one direction while pushing
it against the gear cone. Check that the ring locks.
MT0I0−01