MT−54
C
D
A B
MANUAL TRANSMISSION (RA60)
(c)
If the hub sleeve and clutch hub do not slide smoothly, replace
them.
D13955
5.
(a)
If the runout exceeds the maximum, replace the counter gear
shaft.
D13990
(b)
E
If the diameter is less than the minimum, replace the counter
D13991
gear shaft.
6.
Using a cylinder gauge, measure the inside diameter of the
gear.
If the inside diameter exceeds the maximum, replace the 1st
gear.
D14059
−
COUNTER GEAR
Make sure that the hub sleeve and clutch hub slide
smoothly.
INSPECT COUNTER GEAR SHAFT
Using a dial indicator, measure the shaft runout.
Maximum runout: 0.03 mm (0.0012 in.)
Using a micrometer, measure the outside diameter of the
counter gear shaft journal surface.
Standard:
Part
A
B
C
D
E
Minimum:
Part
A
B
C
D
E
INSPECT 1ST GEAR
Standard inside diameter:
54.015 to 54.040 mm (2.1266 to 2.1276 in.)
Maximum inside diameter:
54.040 mm (2.1276 in.)
Outside diameter mm (in.)
34.002 to 34.015 (1.3387 to 1.3392)
36.985 to 37.000 (1.4561 to 1.4567)
47.985 to 48.000 (1.8892 to 1.8898)
53.985 to 54.000 (2.1254 to 2.1260)
34.002 to 34.015 (1.3387 to 1.3392)
Outside diameter mm (in.)
34.002 (1.3387)
36.985 (1.4561)
47.985 (1.8892)
53.985 (2.1254)
34.002 (1.3387)