4th
4th
SST
MANUAL TRANSMISSION (RA60)
DISASSEMBLY
3rd
1.
Using a feeler gauge, measure the clearance between the gear
and the shaft.
6th
D13938
2.
Using a dial indicator, measure the clearance between the gear
6th
3rd
and the shaft with the needle roller bearing installed.
If necessary, replace the gear, needle roller bearing or shaft.
D13939
3.
(a)
D13940
(b)
(c)
D13941
−
INPUT SHAFT
INSPECT EACH GEAR THRUST CLEARANCE
Standard gear thrust clearance:
Gear
3rd
4th
6th
INSPECT EACH GEAR RADIAL CLEARANCE
Standard gear radial clearance:
Gear
3rd and 4th
6th
REMOVE 6TH GEAR
Using 2 screwdrivers and a hammer, remove the snap
ring.
Using SST and a press, remove the clutch hub No.3, hub
sleeve, synchronizer ring and 6th gear.
SST
09950−00020
Remove the needle roller bearing and ring.
Thrust Clearance mm (in.)
0.09 to 0.52 (0.0035 to 0.0205)
0.12 to 0.38 (0.0047 to 0.0150)
0.20 to 0.49 (0.0079 to 0.0193)
Radial Clearance mm (in.)
0.015 to 0.067 (0.00059 to 0.00264)
0.015 to 0.065 (0.00059 to 0.00256)
MT−31
MT0HV−01