Toyota Tundra 2005 Service - Repair - Maintenance page 2277

MT−34
Inner
MANUAL TRANSMISSION (RA60)
INSPECTION
Middle
1.
Outer
(a)
D13950
If the clearance is less than the minimum, replace the synchro-
nizer ring set No.3.
(b)
D13951
2.
(a)
If the clearance is less than the minimum, replace the synchro-
nizer ring No.3.
D13952
(b)
D13953
− INPUT SHAFT
INSPECT SYNCHRONIZER RING SET NO.3
Using a feeler gauge, measure the clearance between
the synchronizer ring set No.3 and the 3rd gear.
Standard clearance:
Inner: 1.20 to 2.20 mm (0.0472 to 0.0866 in.)
Middle: 0.60 to 1.80 mm (0.0236 to 0.0709 in.)
Outer: 0.80 to 1.80 mm (0.0315 to 0.0709 in.)
Minimum clearance:
Inner: 1.20 mm (0.0472 in.)
Middle: 0.60 mm (0.0236 in.)
Outer: 0.80 mm (0.0315 in.)
Coat the 3rd gear cone with gear oil. Check the braking
effect of the synchronizer ring. Turn the synchronizer ring
in one direction while pushing it against the 3rd gear cone.
Check that the ring locks.
INSPECT SYNCHRONIZER RING NO.3
Using a feeler gauge, measure the clearance between
the synchronizer ring No.3 and the 4th gear.
Standard clearance:
0.70 to 1.50 mm (0.0276 to 0.0591 in.)
Minimum clearance:
0.70 mm (0.0276 in.)
Coat the 4th gear cone with gear oil. Check the braking
effect of the synchronizer ring. Turn the synchronizer ring
in one direction while pushing it against the 4th gear cone.
Check that the ring locks.
MT0HW−01