Test Cam Usage; View Cam-Acl Settings - Dell Z9500 Configuration Manual

NOTE: If you do not enter the allocation values for the CAM regions, the value is 0.
3 Execute write memory and verify that the new settings are written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4 Reload the system.
EXEC Privilege mode
reload

Test CAM Usage

To determine whether sufficient CAM space is available to enable a service-policy, use the test-cam-usage command. To
verify the actual CAM space required, create a Class Map with all required ACL rules, then execute the test cam-usage
command in Privilege mode. The Status column in the command output indicates whether or not you can enable the policy.
Example of the test cam-usage Command
Dell# test cam-usage service-policy input pcam linecard all
linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status
------------------------------------------------------------------------------------------
0 |
0 |
0 |
1 |
1 |
1 |
1 |
2 |
2 |
2 |
2 |

View CAM-ACL Settings

The show cam-acl command shows the cam-acl setting that will be loaded after the next reload.
Example of Viewing CAM-ACL Settings
Dell# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos :
L2PT :
IpMacAcl :
VmanQos :
EcfmAcl :
Openflow :
-- linecard 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos :
L2PT :
IpMacAcl :
VmanQos :
0 | IPv4Flow
1 | IPv4Flow
2 | IPv4Flow
0 | IPv4Flow
1 | IPv4Flow
2 | IPv4Flow
3 | IPv4Flow
0 | IPv4Flow
1 | IPv4Flow
2 | IPv4Flow
3 | IPv4Flow
1 block = 256 entries
6
4
0
2
1
0
0
0
0
0
1 block = 256 entries
6
4
0
2
1
0
0
0
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
| 408 |
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
1 | Allowed (408)
Content Addressable Memory (CAM) 207