Permit (Management) - Dell PowerConnect PC5524 Reference Manual

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
For IPv6 management traffic that is tunneled in IPv4 packets, the
management ACL is applied first on the external IPv4 header (rules with
service field are ignored), and then again on the inner IPv6 header.
Example
The following example creates a management access list called mlist,
configures management gigabitethernet interfaces 1/0/1 and 1/0/9, and
makes the new access list the active list.
Console(config)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config)#
The following example creates a management access list called 'mlist',
configures all interfaces to be management interfaces except
gigabitethernet interfaces 1/0/1 and 1/0/9, and makes the new
access list the active list.
Console(config)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config)#

permit (Management)

The permit Management Access-List Configuration mode command sets
conditions for the management access list.
Syntax
[interface-id] [service service]
permit
permit ip-source {
{mask | prefix-length}] [interface-id] [service service]
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
152
Management ACL Commands
CLI\files\Management_ACL.fm
management access-list
permit
permit
exit
management access-class
management access-list
gigabitethernet 1/0/1
deny
gigabitethernet 1/0/9
deny
permit
exit
management access-class
ipv4-address ipv6-address
|
mlist
gi1/0/1
gi1/0/9
mlist
mlist
mlist
ipv6-prefix-length
/
[mask
}