Delete Startup Configuration; Configure Out Of Band (Oob) Management Port; Configure Route For Oob Management Port (Optional); Configure Login Credentials - Dell S4048-ON Configuration Manual

Switch configuration (OS 9.x)
2.1.2

Delete startup configuration

Note: The following commands will delete all configuration settings.
Dell>enable
Dell#delete startup-config
Proceed to delete startup-config [confirm yes/no]yes
Dell#reload
System configuration has been modified. Save? [yes/no]no
Proceed with reload [confirm yes/no]yes
Note: The switch will reboot.
2.1.3

Configure out of band (OOB) management port

Dell>enable
After the startup configuration is deleted, the factory default enable mode password is calvin.
Dell>#configure
Dell(conf)#interface ManagementEthernet 1/1
Dell(conf-if-ma-1/1)#no shutdown
Dell(conf-if-ma-1/1)#ip address <ipaddress> <mask>
Dell(conf-if-ma-1/1)#exit
2.1.4

Configure route for OOB management port (optional)

Dell(conf)#management route <X.Y.Z.0> /24 <A.B.C.1>
Note: In the previous command, <X.Y.Z.0> is the network your management system is connecting from and
<A.B.C.1> is the gateway for the switch. If your management system is on the same subnet as the switch, the
previous step may be omitted. The prior example assumes a class C subnet mask.
2.1.5

Configure login credentials

Dell(conf)#username admin privilege 15 password 0 <yourpassword>
Dell(conf)#enable password level 15 0 <yourpassword>
9 Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026