Show Ip Management-Route - Dell S4810 Reference Manual

show ip management-route

View the IP addresses assigned to the Management interface.
S4810
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all
connected
summary
static
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Example
Dell#show ip management-route
Destination
-----------
10.1.2.0/24
172.16.1.0/24
Dell#
900
(OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
(OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
(OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
(OPTIONAL) Enter the keyword static to view non-active
routes also.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
Gateway
-------
ManagementEthernet 0/0
10.1.2.4
State
-----
Connected
Active
IPv4 Routing