Ip Helper-Address Hop-Count Disable - Dell Force10 Z9000 Reference Manual

ip helper-address hop-count disable

Disable the hop-count increment for the DHCP relay agent.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip helper-address hop-count disable
To re-enable the hop-count increment, use the no ip helper-address hop-count
disable command.
Defaults Enabled; the hops field in the DHCP message header is incremented by default.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.3.1.0
Usage This command disables the incrementing of the hops field when boot requests are relayed to a
Information DHCP server through FTOS. If the incoming boot request already has a non-zero hops field, the
message is relayed with the same value for hops. However, the message is discarded if the
hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542.
Related
ip helper-address
Commands
requests.
show running-config
ip host
Assign a name and IP address to be used by the host-to-IP address mapping table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name
ip address
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
– specifies the destination broadcast or host address for DHCP server
– displays the current configuration and changes from the default values.
Enter a text string to associate with one IP address.
Enter an IP address, in dotted decimal format, to be mapped to the
name.
789