Ip Helper-Address Hop-Count Disable - Dell C9000 Series Reference Manual

Version
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage Information You can only configure one domain name with the ip domain-name command. To
configure more than one domain name, configure the ip domain-list command up
to six times.
To enable dynamic resolution of hosts, use the following steps:
To view current bindings, use the show hosts command.
Related
ip domain-list
Commands

ip helper-address hop-count disable

Disable the hop-count increment for the DHCP relay agent.
C9000 Series
Syntax
ip helper-address hop-count disable
To re-enable the hop-count increment, use the no ip helper-address hop-
count disable command.
Defaults Enabled; the hops field in the DHCP message header is incremental by default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Description
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
— configures additional names.
Description
Introduced on the C9010.
Introduced on the Z9500.
IPv4 Routing 1192