Ip Domain-Lookup - Dell Z9500 Reference Manual

the name is not resolved, the software goes through the list of names configured
with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
•
•
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related ip domain-name
Commands

ip domain-lookup

To address resolution (that is, DNS), enable dynamic host-name.
Z9500
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage
To fully enable DNS, also specify one or more domain name servers with the ip
Information
name-server command.
912
specify a domain name server with the ip name-server command
enable DNS with the ip domain-lookup command
— specifies a DNS server.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
IPv4 Routing