9-372 Xerographic Cru (Drum) Not In Position Rap; 9-374 Waste Bottle Not In Position Rap - Xerox DocuColor 12/DCCS50 Service Manual

9-372 Xerographic CRU (Drum) Not In Position RAP

Xerographic CRU (Drum) not in Position. The Control Logic detected that the Xerographic CRU
(Drum) is not installed in the machine.
Initial Actions
Refer to BSD 9.1 for the following procedure.
Ensure that P/J422A on the IOT Drive PWB and
graphic CRU (Drum) is properly installed before beginning this RAP.
Procedure
Go to Flag 8 on BSD 9.1. Check the harness for an open or a short circuit. If the harness is
good, replace the Xerographic CRU (Drum).
If the problem continues, replace the IOT Drive PWB
NOTE: Check GP 15 Setting the Machine for a Time & Materials (T & M)
that the CRU is compatible with the machine service contract.
Status Indicator RAPs
9-372 Xerographic CRU (Drum) Not In Position RAP,
P/J713 are connected and that the Xero-
(PL 9.2).
Account, to ensure
manuals4you.com manuals4you.com

9-374 Waste Bottle Not In Position RAP

This status code is declared when the sensor detects the there is no Waste Bottle, or that the
Waste Bottle has been improperly installed.
Initial Actions
Refer to BSD 9.13 and BSD 9.15 for the following procedure.
Check that the Waste Bottle is in place, and that the actuator is not deformed. Check the Waste
Toner Bottle Sensor for dirt or foreign matter.
Procedure
Enter dC330 009-249 Waste Bottle Position Sensor. Press Start. The Display is (L)
Y N
Check the Waste Toner Bottle Sensor for intermittent operation. If there is intermittent
operation, replace the Waste Toner Bottle Sensor
replace the IOT Drive PWB (PL
Less than +1 VDC is measured between P/J413-B4 and GND on the IOT Drive PWB.
Y N
Replace the IOT Drive PWB (PL
Go to Flag 2 on BSD 9.13. Check the wire for a short circuit to ground. If the wire is good,
replace the Waste Toner Bottle Sensor
1/05
2-124
(PL 5.2). If the problem continues,
9.2).
9.2).
(PL 5.2).
DocuColor 12/DCCS50
Reissue