Debug Protocol-Tunnel - Dell C9000 Series Reference Manual

debug protocol-tunnel

Enable debugging to ensure incoming packets are received and rewritten to a new MAC address.
C9000 Series
Syntax
debug protocol-tunnel interface {in | out | both} [vlan vlan-id]
[count value]
To disable debugging, use the no debug protocol-tunnel interface {in |
out | both} [vlan vlan-id] [count value] command.
Parameters
interface
in | out | both
vlan vlan-id
count value
Defaults Debug disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
Enter one of the following interfaces and slot/port information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and outgoing
interfaces.
Enter the keyword vlan then the VLAN ID. The range is from 1
to 4094.
Enter the keyword count then the number of debug outputs.
The range is from 1 to 100.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Service Provider Bridging 2017