Changing Oil, Axis-1 Gearbox - ABB IRB 8700 Product Manual

Hide thumbs Also See for IRB 8700:

Table of Contents

3 Maintenance

3.4.2 Changing oil, axis-1 gearbox

Usage of dispenser

The oil change procedure in this section describes usage of an oil dispenser.

Location of oil plugs

The oil plugs of the gearbox are located as shown in the figure.

Bottom right

Required consumable

Lubricating oil

Required tools and equipment

Equipment, etc.

Oil collecting vessel

Continues on next page

Ventilation plug (can also be used for filling oil, when not

using an oil dispenser)

Inspection plug

Draining and filling (fitted with nipple intended for use of a

oil dispenser when filling or draining oil)

Information about the oil is found in Technical refer-

ence manual - Lubrication in gearboxes.

Article number

Type and amount of oil in gearboxes on page

The capacity of the vessel must be

sufficient to take the complete amount

Product manual - IRB 8700

3HAC052853-001 Revision: M

Irb 8700 - 550/4.20 Irb 8700 - 800/3.50