ABB IRB 8700 Product Manual page 54

2 Installation and commissioning
2.3.1 Lifting the robot with fork lift accessory set installed
Continued
5
6
7
Lifting with the fork lift accessory set
Preparations before lifting
1
Continues on next page
54
Action
Attach the fork lift accessory pockets (4 pcs).
Note
Make sure that the original screws are used. If
need to replace any of the screws, use screws
with equivalent quality.
DANGER
Never attach a fork lift pocket with only one attach-
ment screw.
Secure the fork lift accessory pockets.
CAUTION
Do not lift the robot at this point; the robot is still
secured to the foundation.
The remaining attachment screws, that secure
the robot to the foundation, will be removed after
the fork lift truck has its forks inserted into the
fork lift accessory pockets.
Action
Make sure that any tool attached on the turning
disc, has been removed before lifting.
Note
No tool is permitted to be fitted on the robot, when
lifting the robot with the fork lift accessory set.
© Copyright 2015-2020 ABB. All rights reserved.
Note
A
B
C
A CE label
B Fork lift accessory pocket (4
pcs)
C Attachment screws MC6S
20x60 8.8 (2 pcs x4)
Tightening torque: 300 Nm
Note
Note
No extra load is permitted on the
robot.
DressPack cable package can stay
fitted as long as the tool has been
removed.
Product manual - IRB 8700
3HAC052853-001 Revision: M