3
4
5
Removing the cable harness in the lower arm
1
2
Product manual - IRB 8700
3HAC052853-001 Revision: M
Action
Cut the cable ties that secure the axis-1,
axis-2 and axis-3 motor cables to the axis-
1 bracket.
Unscrew the screws that hold the axis-1
bracket (4 pcs).
Use caution and pull out the cables from
the axis-1, axis-2 and axis-3 motors.
Action
DANGER
Make sure that all supplies for electrical
power, hydraulic pressure, and air pressure
are turned off.
If not already done, unscrew the screws
that hold the two cable brackets inside the
lower arm.
Note
The screws are reached from the outside.
© Copyright 2015-2020 ABB. All rights reserved.
4.4.1 Removing the cable harness
Note
xx1500002372
Note
xx1500002695
Continues on next page
4 Repair
Continued
205