ABB IRB 8700 Product Manual page 500

4 Repair
4.7.4 Replacing the axis-5 motor
Continued
Equipment, etc.
Removal tool M12
Rotation tool
Leak-down tester
Standard toolkit
Required consumables
Consumable
Grease
Flange sealant
Cable ties
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Continues on next page
500
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
© Copyright 2015-2020 ABB. All rights reserved.
Article number Note
3HAC14631-1 Used to push out the motor if neces-
sary.
Always use removal tools in pairs.
3HAC7887-1 Used to rotate the motor pinion.
-
- Content is defined in section
toolkit on page
Article number
3HAC063069-001
12340011-116
-
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
routine on page
Standard
733.
Note
Castrol Molub. Alloy 777-1 NG, 5
ml. To be used on hub splines to
prevent from fretting corrosion.
Loctite 574
Reference calibration
702.
Product manual - IRB 8700
3HAC052853-001 Revision: M