ABB IRB 8700 Product Manual page 223

4
5
6
7
Product manual - IRB 8700
3HAC052853-001 Revision: M
Action
Refit the cable clamp on the axis-3 bracket.
Refit the cable clamp on the axis-3 bracket,
between axis-4 motor and arm housing.
Secure the cable harness with a cable tie.
Make sure that the gasket on the cover is
correctly fitted.
Note
Replace if damaged.
The gasket is covered with adhesive on the
side facing the upper arm cover. The three
washers are pressed into the holes in the
gasket. Make sure all three washers are
fitted.
© Copyright 2015-2020 ABB. All rights reserved.
4.4.2 Refitting the cable harness
Note
xx1500002718
xx1500003092
xx1500003093
xx1500003094
Continues on next page
4 Repair
Continued
223