Subaru IMPREZA GD 2007 Series Manual page 3853

asieps_tobira_IM_US.book 24 ページ ２０１２年１月１７日 火曜日 午後３時４８分
GLASS/WINDOWS/MIRRORS
13.Windshield Glass
A: REMOVAL
1. WHEN USING WINDSHIELD GLASS
KNIFE
1) Disconnect the wiper deicerconnector. (Model
with wiper deicer)
2) Remove the cowl panel. <Ref. to EI-34, RE-
MOVAL, Cowl Panel.>
3) Remove the glass molding.
4) Tape the body side of the circumference of wind-
shield glass for protection.
5) Apply sufficient amount of soapy water to the ad-
hesive part.
6) Make a cut in the adhesive part using a putty
knife so that windshield glass knife can be inserted
easily.
7) Insert the windshield glass knife into the adhe-
sive.
8) While holding the knife edge and windshield
glass edge at a right angle, move the windshield
glass knife in parallel to the windshield glass edge
along the surface and edge of windshield glass to
cut the adhesive part.
NOTE:
• Do not twist the windshield glass knife.
• Cutting of adhesive part shall be started with wid-
er gap between windshield glass and body.
(3)
A-A
(2)
(2)
(1) Tape for protection
(2) Locating pin
(3) Windshield glass knife
Windshield Glass
(1)
(3)
(3)
(1)
A
(3)
A
GW-00543
GW-24
• The locating pins are bonded to the corners of
glass. Use piano wire to disconnect the pins.
(1)
A
A
(1) Locating pin
(2) Body panel
(3) Windshield glass
2. WHEN USING PIANO WIRE
1) Disconnect the wiper deicerconnector. (Model
with wiper deicer)
2) Remove the cowl panel. <Ref. to EI-34, RE-
MOVAL, Cowl Panel.>
3) Remove the glass molding.
4) Tape the body side of the circumference of wind-
shield glass for protection.
5) Make a hole in the adhesive part using drill or
knife.
6) Pass the piano wire through the hole, and attach
both the wire ends securely to pieces of wood.
7) Pull the wire ends alternately to cut off the adhe-
sive part.
CAUTION:
• Do not tightly pull the piano wire against the
windshield glass edge.
• Be careful not to damage interior and exterior
parts.
• Do not cross piano wires. Otherwise they
may be cut.
• When removal is made with area close to in-
strument panel, place a protection plate over it.
Pay particular attention to the removal.
(2)
(3)
(1)
A-A
GW-00607
GW-00039