Subaru IMPREZA GD 2007 Series Manual page 3843

asieps_tobira_IM_US.book 14 ページ ２０１２年１月１７日 火曜日 午後３時４８分
GLASS/WINDOWS/MIRRORS
9) Make the same adjustment of two adjusting bolts
of rear sash.
A
A
(1) 2.7 — 4.3 mm (0.106 — 0.169 in)
(2) 6 mm (0.236 in)
(3) ST
NOTE:
Do not tilt the sash bracket to inner panel during ad-
justment. If tilting, the regulator does not operate
smoothly.
(1) Sash bracket
(2) Rear sash
(3) Adjust the lines parallel
(4) Sash
(5) Inner panel
10) Make adjustment of front sash in the same
manner as that of rear sash.
NOTE:
Although front and rear sashes must, as a rule, be
adjusted in the same manner, in some door instal-
lation, the adjustment in a different manner may be
required. However, adjustment of one sash to the
maximum amount and the other to the minimum
amount is not permitted. Such adjustment may re-
sult in applying excessive load against regulator.
11) After adjustments, tighten the nuts.
12) After adjustment of the glass, close the door. If
there is a gap between outer lip of gusset and glass
surface, adjust the gap by adjusting bolt (A) at the
attachment hardware at the lower side of the gus-
set to prevent generation of wind noise.
Front Door Glass
(1)
(3)
(2)
GW-00336
(1)
(4)
(3)
(2)
(5)
GW-00245
GW-14
13) During adjustment, loosen the other three
clamping bolts.
(A)
14) After adjustment, tighten the bolts and nuts.
GW-00220