Subaru IMPREZA GD 2007 Series Manual page 3855

asieps_tobira_IM_US.book 26 ページ ２０１２年１月１７日 火曜日 午後３時４８分
GLASS/WINDOWS/MIRRORS
7) Apply the primer to the adhesive layer of body.
Painted surface primer:
Dow Automotive
ESSEX U-413 or equivalent
NOTE:
• Primer once attached to the painted surface of
the body and internal trim is hard to wipe off. Mask
the circumference of such area.
• Let primer dry for about ten minutes before in-
stalling the glass.
• Do not touch the surface coated with primer.
(2)
(1) Application of primer
(2) Glass side
(3) Body side
8) Cut off the cartridge nozzle tip as shown and set
it in sealant gun.
(1) 10 mm (0.39 in)
(2) 15 mm (0.59 in)
Windshield Glass
(1)
(3)
GW-00073
(1)
(2)
GW-00238
GW-26
9) Apply adhesive to the glass end surface as shown.
Adhesive:
Dow Automotive
ESSEX U-400HV or equivalent
(1)
(1) 12 — 15 mm (0.47 — 0.59 in)
10) Fit the locating pins using suction rubber cup
and install windshield glass.
11) Lightly press the windshield glass for tight fit.
12) Make flush the adhesive surface jutted out us-
ing spatula.
13) Connect the wiper deicer connector. (Model
with wiper deicer)
14) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass first, and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
15) After curing of adhesive, pour the water on ex-
ternal surface of vehicle to check that there are no
water leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
16) Install the cowl panel. <Ref. to EI-34, INSTAL-
LATION, Cowl Panel.>
GW-00239
GW-00045