Rear Gate Glass - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 27 ページ ２０１２年１月１７日 火曜日 午後３時４８分

14.Rear Gate Glass

A: REMOVAL
1) Remove the rear wiper motor. <Ref. to WW-17,
REMOVAL, Rear Wiper Motor.>
2) Disconnect the electrical connectors from rear
defogger terminal.
3) Remove the glass in the same procedure as for
windshield glass. <Ref. to GW-24, REMOVAL,
Windshield Glass.>
B: INSTALLATION
1) Apply adhesive in the same procedure as for
windshield glass. <Ref. to GW-25, INSTALLA-
TION, Windshield Glass.>
2) Insert the glass locating pin into rear gate hole,
push on the area around the locating pin to secure
it, and then push lightly all around the area to seal
it.
3) About one hour after installation, conduct a leak
test.
(1)
(4)
(5)
(8)
(1) Upside
(2) Molding
(3) Glass
(4) Adhesive
(5) Downside
(6) Glass
(7) Molding
(8) Adhesive
Rear Gate Glass
(2)
(3)
(6)
(7)
GW-00240
GW-27
GLASS/WINDOWS/MIRRORS
4) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass first, and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
• When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
5) Connect the rear defogger terminals.
6) Install the rear wiper. <Ref. to WW-17, INSTAL-
LATION, Rear Wiper Motor.>