Rear Window Glass - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 28 ページ ２０１２年１月１７日 火曜日 午後３時４８分
GLASS/WINDOWS/MIRRORS

15.Rear Window Glass

A: REMOVAL
1) Disconnect the electrical connectors from the
rear defogger terminal and the antenna terminal.
2) Remove the glass in the same procedure as for
windshield glass. <Ref. to GW-24, REMOVAL,
Windshield Glass.>
B: INSTALLATION
1) Install the dam rubber.
(1)
(2)
(5)
(7)
(1) Locating pin
(2) Dam rubber
(3) Fastener
(4) 16.5 mm (0.65 in)
(5) 8 mm (0.315 in)
(6) 22 mm (0.866 in)
(7) R20
Rear Window Glass
(4)
(3)
(6)
GW-00241
GW-28
2) Attach the molding to the glass.
CAUTION:
Press the adhesive surface of double-sided
tape evenly and firmly to prevent any floating of
the tape.
(4)
(2)
(1) Glass
(2) Molding
(3) Double-sided tape
(4) Gap of 0.7 mm (0.03 in) or less
3) Install the glass in the same procedure as for
windshield glass. <Ref. to GW-25, INSTALLA-
TION, Windshield Glass.>
4) Connect the rear defogger terminal and the an-
tenna terminal.
5) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass first, and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
6) After curing of adhesive, pour the water on exter-
nal surface of vehicle to check that there are no wa-
ter leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
(1)
(3)
GW-00587