Subaru IMPREZA GD 2007 Series Manual page 3812

asieps_tobira_IM_US.book 47 ページ ２０１２年１月１７日 火曜日 午後３時４８分
20.Instrument Panel Assembly
A: REMOVAL
CAUTION:
• Airbag system wiring harnesses and connec-
tors are yellow. Do not use the electrical test
equipment on these circuits.
• Be careful not to damage the airbag system
harness when servicing the instrument panel.
1) Disconnect the ground cable from the battery.
2) Loosen the screw (A), disconnect the connec-
tors, and remove the instrument panel lower cover.
3) Remove the console front panel and console
cover. <Ref. to EI-46, REMOVAL, Console Box.>
4) Remove the clips (A), and remove the center
console panel.
:(A)
5) Remove the glove box. <Ref. to EI-43, REMOV-
AL, Glove Box.>
6) Loosen the screws to remove the console side
panel.
7) Remove the passenger airbag module. <Ref. to
AB-14, Passenger's Airbag Module.>
Instrument Panel Assembly
8) Loosen four screws and two nuts to remove the
console cover.
9) Remove the hook, and then remove the defrost-
(A)
er grille.
EI-00483
10) Remove the front pillar upper trim. <Ref. to EI-
50, REMOVAL, Upper Inner Trim.>
11) Disconnect the two connectors and loosen the
nut.
EI-01014
EI-01112
EI-47
EXTERIOR/INTERIOR TRIM
EI-01113
EI-00489
EI-00491