Subaru IMPREZA GD 2007 Series Manual page 3860

asieps_tobira_IM_US.book 31 ページ ２０１２年１月１７日 火曜日 午後３時４８分
18.Rear Quarter Glass
A: REMOVAL
Remove the glass in the same procedure as for windshield glass. <Ref. to GW-24, REMOVAL, Windshield
Glass.>
B
B
A
A
A-A
(4)
(3)
(1) Rear quarter glass
(2) Molding
B: INSTALLATION
1) Cut off the nozzle tip as shown in the figure.
(7)
(6)
(1) Locating pin
(2) Dam rubber
(3) Adhesive
(4) Molding
(5) 12 — 15 mm (0.47 — 0.59 in)
(6) 15 mm (0.59 in)
(7) 10 mm (0.39 in)
Rear Quarter Glass
(5)
C
C
(1)
(2)
(3) Adhesive
(4) Dam rubber
(1)
(2)
(3)
(4)
(5)
GW-00609
GW-31
GLASS/WINDOWS/MIRRORS
C-C
(5)
(3)
(2)
B-B
(3)
(2)
(1)
(5) Locating pin
(6) Rear gate glass
2) Install the glass in the same procedure as for
windshield glass. <Ref. to GW-25, INSTALLA-
TION, Windshield Glass.>
3) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass first, and then
open/close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
4) After curing of adhesive, pour the water on exter-
nal surface of vehicle to check that there are no wa-
ter leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
(6)
(2)
(1)
(5)
GW-00242