Subaru IMPREZA GD 2007 Series Manual page 3841

asieps_tobira_IM_US.book 12 ページ ２０１２年１月１７日 火曜日 午後３時４８分
GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure the slider (front) and roller (rear) of
glass is placed securely in the front and rear
sash.
2) Adjust the front door glass. <Ref. to GW-12, AD-
JUSTMENT, Front Door Glass.>
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting nuts of
stabilizer (inner), upper stopper and sash are loose
and door glass rises until it makes contact with the
weather strip.
1) Temporarily tighten the adjusting bolt on one
side of the rear sash, at the midpoint of the slotted
hole in the inner panel.
2) Temporarily tighten the regulator B channel at
the top position of slotted hole.
3) Lower the door glass 10 — 15 mm (0.39 — 0.59
in) from fully closed position. While applying an out-
ward pressure F of 45.0±5.0 N (4.5±0.5 kgf,
9.9±1.1 lbf) to the upper edge of the glass above
the midpoint of the stabilizers (outer), press the sta-
bilizer (inner) to the glass at a pressure of 30±5 N
(3.0±0.5 kgf, 6.6±1.1 lbf) to secure it.
(1)
(4)
(2)
(1) Fully closed position
(2) Stabilizer (outer)
(3) 10 — 15 mm (0.39 — 0.59 in)
(4) Upper stopper
Front Door Glass
F
(3)
A A
(2)
A = A
(4)
GW-00398
GW-12
4) To adjust the clearance between front glass and
center pillar cover, loosen nuts (A), and move the
glass sash back and forth until the clearance be-
comes the value shown.
(1)
A A
(1) 12 mm (0.472 in)
5) To adjust the upper end and lower end of the
center pillar, loosen the adjusting nut (A) of B chan-
nel (B).
(A)
GW-00216
(1)
A-A
GW-00064
(B)
(A)
GW-00092