Subaru IMPREZA GD 2007 Series Manual page 3804

asieps_tobira_IM_US.book 39 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2) Apply masking tape around the double-sided
tape remaining on the surface of body or spoiler.
3) Apply solvent uniformly on the double-sided tape
using a brush.
CAUTION:
• Do not use solvent to the body which has
been repaired with lacquer paint.
• Wipe off immediately when the solvent is at-
tached on surface of the body or spoiler.
Solvent:
3M 8907 or equivalent
4) Cover the area where solvent is applied using
plastic wrap (A), and then heat the double-sided
tape for 5 to 10 minutes at 40 — 60°C (104 —
140°F) using a infrared light (B).
(A)
(A)
CAUTION:
Do not heat the double-sided tape until the sur-
face becomes white and excessively dried.
5) Remove the double-sided tape using a plastic
spatula.
6) After completely removing the double-sided
tape, detach the masking tape and clean the sur-
face using a cotton cloth damped with white gaso-
line.
Side Protector
B: INSTALLATION
1) Apply primer to the protector surface where the
double-sided tape is to be adhered, and then ad-
here the double-sided tape as shown in the figure.
Primer:
3M K-500 or equivalent
Double-sided tape:
3M 5531-5 or equivalent
2) Heat the adhering part using a heat light.
Body side: 40 — 60°C (104 — 140°F)
(B)
Protector side: 20 — 30°C (68 — 86°F)
EI-00155
3) Peel off the backing sheet of double-sided tape,
align the clip position, and then adhere the tape to
the body while taking care to avoid air entering.
CAUTION:
To keep the adhesion, do not wash the vehicle
within 24 hours from installation.
(B)
EI-00156
EI-39
EXTERIOR/INTERIOR TRIM
(1)
(1) Double-sided tape: thickness 1.2 mm (0.047 in),
width 5 mm (0.197 in)
(1)
EI-00536