Subaru IMPREZA GD 2007 Series Manual page 3854

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1) Clean the external circumference of windshield
glass with alcohol or white gasoline.
2) Remove the adhesive layer on the body using cut-
ter knife to obtain smooth face of 2 mm (0.08 in) thick.
CAUTION:
Be careful not to damage the body and paint
surface.
(1)
(1) Adhesive
(2) 2 mm (0.08 in)
(3) Dam rubber
(4) Glass
3) Clean the body with alcohol or white gasoline to
eliminate cutting powder, dust and dirt completely
from body.
(1)
(2)
(5)
(1) Locating pin
(2) Dam rubber
(3) Fastener
(4) 15 mm (0.591 in)
(5) 11 mm (0.433 in)
Windshield Glass
(3)
(2)
(4)
GW-00071
(5)
(3)
(4)
GW-00608
GW-25
GLASS/WINDOWS/MIRRORS
4) Install the dam rubber.
5) Fit the mark (B) on molding to the notch (A) of
glass side, and install the molding to entire perime-
ter of glass.
(B)
6) Apply two types of primers to the adhesive layer
of glass using sponge.
Glass primer:
Dow Automotive
ESSEX U-401 (base coating) and U-402
(over coating) or equivalent
(A)
GW-00237