Subaru IMPREZA GD 2007 Series Manual page 3803

asieps_tobira_IM_US.book 38 ページ ２０１２年１月１７日 火曜日 午後３時４８分
EXTERIOR/INTERIOR TRIM
12.Side Protector
A: REMOVAL
(A) STI model
1) Slide in a thin thread (A) of 0.8 mm (0.031 in) di-
ameter or less (fishing line etc.) between the body
and the protector, and cut the double-sided tape.
Pull the protector, and remove the clip using the
clip remover.
(A)
Side Protector
NOTE:
• To optimize the effect of solvent, slide the thread
along body without removing the double-sided tape
on the surface of body and spoiler.
• If it is difficult to remove the double-sided tape,
warm it up to approx. 40°C (104°F).
• If the double-sided tape remains thick on the sur-
face due to interfacial peeling, apply solvent after
slicing off the double-sided tape using a cutter.
N N G NG
EI-00153
(A)
(A) Panel
(B) Spoiler
(C) Double-sided tape
EI-38
(A)
EI-01135
O O O O O O O O O O O O O O O OK K
(B) (C)
EI-01586