Subaru IMPREZA GD 2007 Series Manual page 3842

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6) Adjust so that the upper and lower ends of the
center pillar are the same size.
(5)
(6)
(1) Narrow
(2) Wide
(3) Glass tilts too far rearward
(4) Glass tilts too far forward
(5) Raise B channel
(6) Lower B channel
Front Door Glass
(1)
(3)
(2)
(2)
(4)
(1)
GW-00065
GW-13
GLASS/WINDOWS/MIRRORS
7) For glass stroke adjustment, attach ST to the
glass and close the door, and raise the glass until
positional relationship between glass and weather
strip becomes as shown. And secure the glass so
that the upper stopper lightly touches the glass
holder.
ST 61299AE000 SPACER (Glass thickness: 5
mm (0.197 in) for front door
glass)
A
A
(1) 2.7 — 4.3 mm (0.106 — 0.169 in)
(2) 6 mm (0.236 in)
(3) ST
For preventing wind noise, adjust the glass at the
position where tip of gusset is raised up a little.
(A) 0 — 1.5 mm (0 — 0.059 in)
8) After stabilizer adjustment, carry out glass cohe-
sion adjustment. First, visually ensure the position-
al relationship between the retainer & molding and
the glass of the roof side, then start the rear sash
adjustment. Attach the ST to the glass and adjust
two adjusting bolts alternately step by step, to ob-
tain dimensions shown below (cross-section A).
ST 61299AE000 SPACER (Glass thickness: 5
mm (0.197 in) for front door
glass)
NOTE:
If two nuts are loosened at the same time, the sash
moves back and forth. Therefore, when one nut is
adjusted, leave the other secured.
(1)
(3)
(2)
GW-00336
GW-00024