Toyota Tundra 2005 Service - Repair - Maintenance page 2260

MANUAL TRANSMISSION (RA60)
17.
Using a feeler gauge, measure the thrust clearance.
D14067
18.
Remove the reverse idle gear shaft, needle roller bearing and
reverse idler gear.
D13922
19.
Using a dial indicator, measure the radial clearance.
If the clearance exceeds the maximum, replace the needle roll-
er bearing.
D14068
20.
(a)
D13923
(b)
D13924
− MANUAL TRANSMISSION ASSEMBLY
INSPECT REVERSE IDLER GEAR THRUST CLEAR-
ANCE
Standard clearance:
0.10 to 0.55 mm (0.0039 to 0.0217 in.)
Maximum clearance:
0.55 to (0.0217 in.)
REMOVE REVERSE IDLER GEAR
INSPECT REVERSE IDLER GEAR RADIAL CLEAR-
ANCE
Standard clearance:
0.015 to 0.050 mm (0.0006 to 0.0020 in.)
Maximum clearance:
0.050 mm (0.0020 in.)
REMOVE OUTPUT SHAFT, INPUT SHAFT, COUNTER
GEAR SHAFT AND CONTROL SUB ASSEMBLY
Remove the 4 bolts from the control sub assembly.
Securely bind the output shaft, input shaft, counter gear
shaft and control sub assembly together with a belt, etc.
MT−17