Lacp Port-Priority - Dell S4810 Reference Manual

Related show lacp
Commands

lacp port-priority

To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all
compatible ports from aggregating, configure the port priority.
S4810
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-
value command.
Parameters
priority-value
Defaults 32768
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
1032
— displays the LACP configuration.
Enter the port-priority value. The higher the value number,
the lower the priority. The range is from 1 to 65535. The
default is 32768.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Aggregation Control Protocol (LACP)