Creating A Custom Privilege Level; Removing A Command From Exec Mode; Moving A Command From Exec Privilege Mode To Exec Mode; Allowing Access To Configuration Mode Commands - Dell S4048T Configuration Manual

Creating a Custom Privilege Level

Custom privilege levels start with the default EXEC mode command set. You can then customize privilege
levels 2-14 by:
• restricting access to an EXEC mode command
• moving commands from EXEC Privilege to EXEC mode
• restricting access
A user can access all commands at his privilege level and below.

Removing a Command from EXEC Mode

To remove a command from the list of available commands in EXEC mode for a specific privilege level, use
the privilege exec command from CONFIGURATION mode.
In the command, specify a level greater than the level given to a user or terminal line, then the first keyword
of each command you wish to restrict.
Moving a Command from EXEC Privilege Mode
to EXEC Mode
To move a command from EXEC Privilege to EXEC mode for a privilege level, use the privilege exec
command from CONFIGURATION mode.
In the command, specify the privilege level of the user or terminal line and specify all keywords in the
command to which you want to allow access.
Allowing Access to CONFIGURATION Mode
Commands
To allow access to CONFIGURATION mode, use the privilege exec level level configure
command from CONFIGURATION mode.
A user that enters CONFIGURATION mode remains at his privilege level and has access to only two
commands, end and exit. You must individually specify each CONFIGURATION mode command you want
to allow access to using the privilege configure level level command. In the command, specify the
privilege level of the user or terminal line and specify all the keywords in the command to which you want to
allow access.
Management 70