Creating A Custom Privilege Level; Removing A Command From Exec Mode; Moving A Command From Exec Privilege Mode To Exec Mode; Allowing Access To Configuration Mode Commands - Dell S4048–ON Configuration Manual

Creating a Custom Privilege Level

Custom privilege levels start with the default EXEC mode command set. You can then customize privilege levels 2-14 by:
• restricting access to an EXEC mode command
• moving commands from EXEC Privilege to EXEC mode
• restricting access
A user can access all commands at his privilege level and below.

Removing a Command from EXEC Mode

To remove a command from the list of available commands in EXEC mode for a specific privilege level, use the privilege exec
command from CONFIGURATION mode.
In the command, specify a level greater than the level given to a user or terminal line, then the first keyword of each command you wish to
restrict.

Moving a Command from EXEC Privilege Mode to EXEC Mode

To move a command from EXEC Privilege to EXEC mode for a privilege level, use the privilege exec command from
CONFIGURATION mode.
In the command, specify the privilege level of the user or terminal line and specify all keywords in the command to which you want to allow
access.

Allowing Access to CONFIGURATION Mode Commands

To allow access to CONFIGURATION mode, use the privilege exec level level configure command from
CONFIGURATION mode.
A user that enters CONFIGURATION mode remains at his privilege level and has access to only two commands, end and exit. You must
individually specify each CONFIGURATION mode command you want to allow access to using the privilege configure level
level command. In the command, specify the privilege level of the user or terminal line and specify all the keywords in the command to
which you want to allow access.

Allowing Access to Different Modes

This section describes how to allow access to the INTERFACE, LINE, ROUTE-MAP, and ROUTER modes.
Similar to allowing access to CONFIGURATION mode, to allow access to INTERFACE, LINE, ROUTE-MAP, and ROUTER modes, you must
first allow access to the command that enters you into the mode. For example, to allow a user to enter INTERFACE mode, use the
privilege configure level level interface tengigabitethernet command.
Next, individually identify the INTERFACE, LINE, ROUTE-MAP or ROUTER commands to which you want to allow access using the
privilege {interface | line | route-map | router} level level command. In the command, specify the privilege
level of the user or terminal line and specify all the keywords in the command to which you want to allow access.
To remove, move or allow access, use the following commands.
The configuration in the following example creates privilege level 3. This level:
Management 63