Ipv4 Unicast-Host-Route - Dell Z9500 Command Reference Manual

Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0

ipv4 unicast-host-route

Enable the storage of IPv4 route prefixes in the L3 host table.
Z9500
Syntax
[no] ipv4 unicast-host-route
Defaults Disabled; by default, all IPv4 route prefixes are stored installed only in the Longest
Prefix Match (LPM) table.
Command CONFIGURATION
Modes
Command
Version
History
9.5(0.1)
9.3(0.1)
Usage
Route prefixes stored in the L3 host table are managed using ECMP next-hop
Information
forwarding.
A warning message is displayed after you enter the command stating that this
setting takes effect for existing routes only when IPv4 route prefixes are cleared
IPv4 Routing
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the Z9500.
Introduced on the S6000.
957