Show Interface Pfc - Dell Z9500 Reference Manual

Usage Specify a linecard number on the Master switch in a stack.
Information
Example
Dell#sh dcb linecard 2 port-set 0
DCB Status: Enabled, PFC Queue Count: 2
linecard Total Buffer PFC Total Buffer PFC Shared Buffer PFC
Available Buffer
PP
(KB)
---------------------------------------------------------------
---------------------------------
2
496
Dell#

show interface pfc

Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
Syntax
show interface port-type slot/port pfc {summary | detail}
Parameters
port-type slot/
port pfc
{summary |
detail}
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
To clear the PFC TLV counters, use the clear pfc counters interface
Information
port-type slot/port command.
The following describes the show interface pfc summary command shown in
the following example.
Field
Interface
Admin mode is on
Admin is enabled
582
NOTE: show dcb command without options displays DCB buffer details for
all linecards, SFMs, and for all port-pipes.
(KB)
(KB)
0 11210
4992
Enter the port-type slot and port PFC information.
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Description
Introduced on the Z9500.
Description
Interface type with stack-unit and port number.
PFC admin mode is on or off with a list of the configured
PFC priorities. When the PFC admin mode is on, PFC
(KB)
7488
Data Center Bridging (DCB)