Show Dcb; Show Interface Pfc - Dell S6000 Reference Manual

Related dcb-input
Commands

show dcb

Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-
enabled queues.
S6000
Syntax
show dcb [stack-unit unit-number] [port-set port-set port-set
number]
Parameters
unit number
port-set
number
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Usage Specify a stack-unit number on the Master switch in a stack.
Information
Example
Dell# show dcb
stack-unit 0 port-set 0
PFC Queue Count : 2 (current), 2 (configured)

show interface pfc

Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
S6000
Syntax
show interface port-type slot/port pfc {summary | detail}
458
— creates a DCB input policy.
Enter the DCB unit number. The range is from 0 to 5.
Enter the port-set number.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
Data Center Bridging (DCB)