Canon imageRUNNER ADVANCE 6075 Series Service Manual page 85

2
Technology > Main Controller > Controls > HDD Encryption/ Mirroring Kit (optional)
The figure below shows the final screen in initializing the encryption board.
The message as shown in the figure below is shown on the screen.
Select "2" when you initialize the encryption board.
We recommend checking the board connection before starting initialization
Attention!
Once initialization
is started,you
cannot cancel it.
is that OK?
[2]= Yes
[other keys]=No
● Relevant Error Codes
E602 and detailed codes
E code Description Cause
E602 Authentication Error Error in authentication
-2000 between the host
machine and the
encryption board
Failure in Encryption Error in recognition of
Board the encryption board
Device Error Failure in the
encryption board
2 Technology > Main Controller > Controls > HDD Encryption/ Mirroring Kit (optional)
F-2-42
Detection
Actions
Timing
Start-up Check connections between
the encryption board and
the HDD and between the
encryption board and the main
controller 2. This error may be
triggered after replacement
of the encryption board or the
main controller 2. At any rate,
this error disables accesses to
HDD data. When no problem
is found in connections, use
SST to execute Key Clear >
Format > Install System.
T-2-17
E610 and detailed codes
Detailed
E code Cause (Detected Error)
Code
E610 Failure in the HDD encryption key
0001 Failure in the HDD encryption key
(Error in hardware configuration). No
encryption board is installed.
0002 Failure in the HDD encryption key
(Error in hardware configuration).
The memory space is insufficient for
encryption operation.
0101 Failure in the HDD encryption key (Error
in initialization). Failed to initialize the
memory space where the key is stored.
0102 Failure in the HDD encryption key (Error
in initialization). Failed to initialize the
encryption processing unit.
0201 Failure in the HDD encryption key.
Error in the encryption processing unit.
0202 Failure in the HDD encryption key.
Error in the encryption processing unit.
0301 Failure in the HDD encryption key (Error
in the encryption key). Failed to create
the encryption key.
0302 Failure in the HDD encryption key (Error
in the encryption key). Detected the
failure in the encryption key.
0303 Failure in the HDD encryption key (Error
in the encryption key). Detected the
failure in the encryption key.
0401 Failure in the HDD encryption key (Error
in the encryption processing). Error is
detected during the encryption process.
0402 Failure in the HDD encryption key (Error
in the encryption processing). Error is
detected during the decoding process.
2-31
Actions
Ask the user to check the hardware
configuration.
Ask the user to check the hardware
configuration.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by
hardware-related factors.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by
hardware-related factors.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by
hardware-related factors.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by
hardware-related factors.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by
hardware-related factors.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by a
hardware-related factor (SRAM). Note
that this error initializes the HDD.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by a
hardware-related factor (SRAM). Note
that this error initializes the HDD.
Turn OFF/ON the power. If the error is
not recovered, this may be caused by a
hardware-related factor (the encryption
board).
Turn OFF/ON the power. If the error is
not recovered, this may be caused by a
hardware-related factor (the encryption
board).
T-2-18
2-31