Woodward easYgen-2000 Series User Manual page 90

Configuration
Basic Setup > Enter Password
90
Code level
Code level CL0 (User
Level)
Standard password =
none
Code level CL1 (Service
Level)
Standard password = "0
0 0 1"
Code level CL2 (Tempo‐
rary Commissioning
Level)
No standard password
available
Code level CL3 (Com‐
missioning Level)
Standard password = "0
0 0 3"
Once the code level is entered, access to the configu‐
ration menus will be permitted for two hours or until
another password is entered into the control. If a user
needs to exit a code level then code level, CL0 should
be entered. This will block unauthorized configuration
of the control.
A user may return to CL0 by allowing the entered
password to expire after two hours or by changing any
one digit on the random number generated on the
password screen and entering it into the unit.
It is possible to disable expiration of the password by
entering "0000" after the CL1 or CL3 password has
been entered. Access to the entered code level will
remain enabled until another password is entered.
Otherwise, the code level would expire when loading
the standard values (default 0000) via ToolKit.
easYgen-2200/2500 | Genset Control
This code level permits for monitoring of the system
and limited access to the parameters.
Configuration of the control is not permitted.
Only the parameters for setting the language, the
date, the time, and the horn reset time are acces‐
sible.
The unit powers up in this code level.
This code level entitles the user to change selected
non-critical parameters, such as setting the parame‐
ters accessible in CL0 plus Bar/PSI, °C/°F.
The user may also change the password for
level CL1.
Access granted by this password expires two hours
after the password has been entered and the user is
returned to the CL0 level.
This code level grants temporary access to most of
the parameters. The password is calculated from the
random number generated when the password is ini‐
tially accessed.
It is designed to grant a user one-time access to a
parameter without having to give him a reusable
password. The user may also change the password
for level CL1.
Access granted by this password expires two hours
after the password has been entered and the user is
returned to the CL0 level. The password for the tem‐
porary commissioning level may be obtained from the
vendor.
This code level grants complete and total access to
most of the parameters. In addition, the user may
also change the passwords for levels CL1, CL2 and
CL3.
Access granted by this password expires two hours
after the password has been entered and the user is
returned to the CL0 level.
37535B