Can Bus Interfaces - Woodward easYgen-2000 Series User Manual

Installation

CAN Bus Interfaces

Fig. 67: DPC-RS-232 wiring - schematic
3.3 CAN Bus Interfaces
Pin assignment
80
Use the Ethernet CAT 5 cable which is supplied with
1
the DPC-RS-232 converter. The maximum cable
length must not exceed 0.5 m.
For a continuous operation with the direct configuration
cable DPC-RS-232 (e.g. remote control of controller), it
is required to use at least revision F (P/N 5417-557
Rev. F) of the DPC-RS-232. When using a DPC-
RS-232 of an earlier revision, problems may occur in
continuous operation. The shield connector (6.3 mm
tab connector) at the DPC-RS-232 of revision F (P/N
5417-557 Rev. F) and above must be connected to
ground.
Terminal
58
59
Table 36: CAN bus 1
Terminal
56
57
Table 37: CAN bus 2 (easYgen-2200 P2 only)
Terminal
93
94
easYgen-2200/2500 | Genset Control
Description A
max
CAN-L N/A
CAN-H N/A
Description A
max
CAN-L N/A
CAN-H N/A
Description A
max
CAN-L N/A
CAN-H N/A
37535B