Woodward easYgen-2000 Series User Manual page 439

Modbus Applications > Changing Parameter Settings > Configuration Of LogicsMan...
Configuration of the LogicsMan‐
ager "Operation mode AUTO"
Example
Word 0 Word 1
Delay ON Delay OFF
0.00 sec 0.00 sec
0000 (hex) 0000 (hex)
low high low high
byt byte byt byte
e e
0000 (hex) 0000 (hex)
37535B
The operating mode AUTO LogicsManager function (parameter
12510 Ä p.
1. Automatic operating mode is always enabled
n
2. Automatic operating mode is enabled via discrete input
n
Fig. 224: LogicsManager function sample 12510
To configure the "Operat. mode AUTO" LogicsManager function
(parameter
Modbus message must be sent to the easYgen:
Word 2
Logic equation 1*
Sig Oper‐ Sign Oper‐
n 1 ator 1 2 ator 2
And True And
¾
1 0 2 0
"as is"
1020 (hex)
easYgen-2200/2500 | Genset Control
247) can be configured in two different ways:
Refer to Ä Chapter 6.4.4 "Performing Remote Start/
Stop And Acknowledgement" on page 376 for a
detailed configuration of the LogicsManager via HMI or
ToolKit.
12510 Ä p. 247) as indicated in (Fig. 224) the following
Word 3
Logic equation 2*
Sig -/- -/- -/-
n 3
Tru 00 00 00
e
2 0 0 0
"as is"
2000 (hex)
Application
Word 4 Word 5 Word 6
Command Command Command
1 2 3
No. 09.09 No. 00.01 No. 00.01
ID = ID = ID =
527 dec 0 dec 0 dec
020F (hex) 0000 (hex) 0000 (hex)
low high low high low
byt byte byt byte byt
e e e
0F02 (hex) 0000 (hex) 0000 (hex)
high
byte
439