Woodward easYgen-2000 Series User Manual page 583

Simple (function)
If TRUE, the load setpoint 2 is enabled.
Deactivated by default.
Not available in operating modes "STOP" and
"MAN".
[00.83] Setpoint 2 voltage enabled
If TRUE, the voltage setpoint 2 is enabled.
Deactivated by default.
Not available in operating modes "STOP" and
"MAN".
[00.84] Setpoint 2 power factor enabled
If TRUE, the power factor setpoint 2 is enabled.
Deactivated by default.
Not available in operating modes "STOP" and
"MAN".
[00.85] Enable MCB
If TRUE, the MCB is enabled.
TRUE, if discrete input [DI 06] is energized and/
or MCB did not fail to close and/or no mains
phase rotation mismatch is detected.
Only available in operating mode "AUTO" and
application mode .
[00.86] Load-dependent start/stop
If TRUE, load-dependent start/stop is enabled.
Deactivated by default.
Prepared for start request in AUTO and neither
Flag 15 nor Flag 16 are enabled.
Only available in operating mode "AUTO" and
application mode .
[00.8x] Segment no. {y} active; {x} = 7 to 9; {y} = 2 to 4
37535B
Extended (configuration)
easYgen-2200/2500 | Genset Control
LogicsManager Reference > Factory Settings
Appendix
Result
FALSE
FALSE
FALSE
dependent on
[DI 06] and
MCB closure
and mains
phase rotation
FALSE
583