Woodward easYgen-2000 Series User Manual page 336

Operation
Access Via PC (ToolKit) > Connect ToolKit
Fig. 113: Connect dialog
CAN bus connection
336
5. From the main ToolKit window, click Device then click "Con‐
nect", or select the Connect icon
ð The connect dialog will open if the option is enabled.
6. Select the COM port that is connected to the communication
cable.
"Connect" button.
7. Click the
ð The identifier of the device that ToolKit is connected to,
will display in the status bar.
Fig. 114: Communications window
8. If the communications window opens, select
"ToolConfigurator" from the "Tool Device" list and close the
communications window.
ð If the device is security enabled, the login dialog will
appear.
9. Enter the login data if required.
ð Now you are able to edit the easYgen parameters in the
main window.
It is also possible to connect to the unit via CAN bus, if a suitable
CAN adapter is used.
We recommend to use the IXXAT USB-to-CAN con‐
verter which must use the VCI V3 driver.
To connect ToolKit via CAN:
1. Install the required drivers of the USB-to-CAN converter.
2. Connect the unit.
3. Open ToolKit and select a tool.
"Connect" .
4. Select
5. Select the CAN connection in the
6. Configure the correct baud rate and timeout in the properties
dialog of the
The Password for CAN Interface 1 (param‐
eter 10402 Ä p.
to edit the parameters via CAN.
easYgen-2200/2500 | Genset Control
on the toolbar.
Any changes are written automatically to the
control unit's memory after pressing [Enter]
to confirm them..
"Connect" window.
"Connect" window.
91) must be entered before being able
37535B