Woodward easYgen-2000 Series User Manual page 293

ID Parameter
5620 Int. power
factor setpoint
1
5639 Power Factor
setpoint 2
source
37535B
Configure Application > Configure Controller > Power Factor Control
CL Setting range Description
[Default]
06.03 Analog input 3
Analog input 3 is used to control the setpoint
06.04 Analog input 4
Analog input 4 is used to control the setpoint
Notes
The power factor setpoint may be adjusted between 0.71 leading and 0.71
lagging.
Selecting a different data source may cause the controller to not operate
properly.
0 -0.999 to +1.000 The desired power factor may be configured here so that the reactive power
is regulated in the system.
[+1.000]
The designations "+" and "-" stand for inductive/lagging (generator overex‐
cited) and capacitive/leading (generator underexcited) reactive power.
This setpoint is active only in mains parallel operation.
2 Determined by The power factor setpoint 2 source can be selected from the available data
AnalogManager sources.
Though it is possible to select from all available data sources
Ä Chapter 9.3.1 "Data Sources" on page 533 ), only the following data
(
sources may be used:
05.10 Internal power factor setpoint 1
Internal power factor control setpoint 1 (parameter
setpoint 2
[05.11] Internal power factor setpoint 2
Internal power factor control setpoint 2 (parameter
setpoint 2
05.12 Interface power factor setpoint
The setpoint, which is transmitted via the interface, is used as setpoint
05.16 Discrete raise/lower power factor
The setpoint from the discrete raise/lower power factor function is used as
setpoint
06.01 Analog input 1
Analog input 1 is used to control the setpoint
06.02 Analog input 2
Analog input 2 is used to control the setpoint
06.03 Analog input 3
Analog input 3 is used to control the setpoint
06.04 Analog input 4
Analog input 4 is used to control the setpoint
easYgen-2200/2500 | Genset Control
Configuration
5620 Ä p. 293) is used as
5621 Ä p. 294) is used as
293