Woodward easYgen-2000 Series User Manual page 446

Application
Modbus Applications > Changing Parameter Settings > Configuration Of LogicsMan...
Example
Word 0 Word 1
Delay ON Delay OFF
0.00 sec 0.00 sec
0000 (hex) 0000 (hex)
low high low high
byt byte byt byte
e e
0000 (hex) 0000 (hex)
446
Fig. 232: LogicsManager function sample 12540
To configure the "Start w/o Load" LogicsManager function (param‐
eter ID 12540 Ä p.
Modbus message must be sent to the easYgen:
Word 2
Logic equation 1*
Sig Oper‐ Sign Oper‐
n 1 ator 1 2 ator 2
Fal And True And
se
3 0 2 0
"as is"
3020 (hex)
Fig. 233: Modscan32 at address 12541
Copy the complete message of 7 words to address 12541 ff
(12540+1) in one step.
This is shown in (Fig. 233) using the ModScan32 software.
easYgen-2200/2500 | Genset Control
247) as indicated in (Fig. 232) the following
Word 3
Logic equation 2*
Sig -/- -/- -/-
n 3
Tru 00 00 00
e
2 0 0 0
"as is"
2000 (hex)
Word 4 Word 5 Word 6
Command Command Command
1 2 3
No. 00.01 No. 00.01 No. 00.01
ID = ID = ID =
0 dec 0 dec 0 dec
0000 (hex) 0000 (hex) 0000 (hex)
low high low high low
byt byte byt byte byt
e e e
0000 (hex) 0000 (hex) 0000 (hex)
high
byte
37535B