Canopen; Protocol 6000 (Load Share Message) - Woodward easYgen-2000 Series User Manual

Appendix
Data Protocols > CANopen > Protocol 6000 (Load Share...
Modbus CAN
Modicon Start Data
start addr. byte 0
addr. (*1) (Mux)
450102 450101 33
450103 450102 34
450104 450103 34
450106 450105 35
450107 450106 35
450109 450108 36
450110 450109 36
450111 450110 36
9.2.2

CANopen

9.2.2.1

Protocol 6000 (Load Share Message)

General information
520
Param‐ Description
eter ID
Data
byte
Output to external CAN-I/O Relay 10
Output to external CAN-I/O Relay 9
Output to external CAN-I/O Relay 8
Output to external CAN-I/O Relay 7
Output to external CAN-I/O Relay 6
Output to external CAN-I/O Relay 5
Output to external CAN-I/O Relay 4
Output to external CAN-I/O Relay 3
Output to external CAN-I/O Relay 2
Output to external CAN-I/O Relay 1
5,6 internal
1,2 5541 Setpoint frequency
3,4,5,6 5542 Setpoint active power
1,2 5641 Setpoint power factor
3,4,5,6 5640 Setpoint voltage
1,2
3,4
5,6
The load share message contains all data, which is required for
load/var sharing, load-dependent start/stop and dead bus detec‐
tion.
Further data, which is exchanged between the control units con‐
cerns time synchronization and parameter alignment. Parameter
alignment is intended for those parameters, which must be config‐
ured identically for all units participating in load sharing, to ensure
a proper operation of load sharing or load-dependent start/stop.
In order to lower the bus load, the messages are divided into "fast",
"normal", and "slow" refreshed data. The mux is identified accord‐
ingly with "F", "N", and "S" (refer to the following tables). The load
share message contains one fast, two normal, and four slow mes‐
sages, which are made up as in
tion" on page 522 .
easYgen-2200/2500 | Genset Control
Multiplier
Mask: 0200h
Mask: 0100h
Mask: 0080h
Mask: 0040h
Mask: 0020h
Mask: 0010h
Mask: 0008h
Mask: 0004h
Mask: 0002h
Mask: 0001h
0.01
0.1
0.001
1
Ä "Load share bus communica‐
Units
Bit
Bit
Bit
Bit
Bit
Bit
Bit
Bit
Bit
Bit
Hz
kW
V
37535B