Woodward easYgen-2000 Series User Manual page 395

easYgen settings
ID Parameter
3163 Baudrate
3161 Parity
3162 Stop bits
Table 77: easYgen settings
ToolKit settings
Fig. 180: Connect modem
Landline modem settings
37535B
Special Applications > Connecting A Landline Modem
1. Configure the following parameters to connect to the modem
for configuration purposes (the same settings must be config‐
ured in the modem):
Value Comment
4.8 kBd The baud rate is set to 4.8 kBaud
No The transmission protocol is configured without parity
One The transmission protocol is configured with one stop bit
2. Configure the relay(s) connected with the modem using the
easYgen LogicsManager (
Overview" on page 549 ).
In ToolKit, select
open the
Select the modem (this must be installed and configured
under Windows) from the network list, enter the phone
number and click the
nection with the modem.
Phoenix provides an application software to configure the modem
for the application.
Descriptions of the individual parameters can be taken
from the operation manual of the modem.
easYgen-2200/2500 | Genset Control
If the transmission quality of the phone line is
poor, the baud rate should be lowered since no
data flow control is performed between easYgen
and modem.
Generally, the connection via modem is a bit
slower than a direct connection of PC and
easYgen.
The maximum baud rate depends on the used
modem. The easYgen supports the following
baud rates: 2400, 4800, 9600, 14400, 19200,
38400, 65000, and 115000 Bauds.
Ä Chapter 9.4.1 "LogicsManager
"Connect..." from the "Device" menu to
"Communications" window.
"Connect" button to establish a con‐
Application
395