Group 04: Applications Condition - Woodward easYgen-2000 Series User Manual

Appendix
LogicsManager Reference > Logical Command Variables > Group 04: Applications Con...
No. ID
03.13 191
03.14 192
03.15 193
03.16 194
03.17 195
03.18 196
03.19 197
03.20 198
03.21 199
03.22 200
03.23 201
03.24 202
03.25 203
03.26 204
03.27 205
03.28 206
03.29 207
03.30 208
03.31 209
9.4.4.5

Group 04: Applications Condition

564
Name / Function
Blinking lamp ECU
ECU special ignition
Reserved
Reserved
Reserved
Reserved
Reserved
Three-position controller
output: frequency / active
power (governor) raise
Three-position controller
output: frequency / active
power (governor) lower
Three-position controller
output: voltage / reactive power
(AVR) raise
Three-position controller
output: voltage / reactive power
(AVR) lower
Reserved
Reserved
Reserved
Stopping solenoid (Diesel)
Operating solenoid (Diesel)
Gas valve (Gas)
Reserved
Auxiliary services prerun
Auxiliary services postrun
Applications condition
n
Logic command variables 04.01-04.60
n
easYgen-2200/2500 | Genset Control
Note
TRUE as soon as the ECU activates the diagnosis light (only for
Scania S6 ECU). This command variable is only active if remote
control of the ECU via easYgen is activated.
TRUE as long as a reset or read-out of the Scania S6 ECU blink
code is requested (only for S6 Scania ECU). This command vari‐
able is only active if remote control of the ECU via easYgen is
activated.
TRUE if the respective three-position controller issues the respec‐
tive control pulse
TRUE if a stop signal is issued until the stop time of engine
expires
TRUE if the fuel solenoid (Diesel) or gas valve (gas) relay is ener‐
gized
TRUE, if "Auxiliary services prerun" is active
TRUE, if "Auxiliary services postrun" is active
37535B