Relay Outputs (Logicsmanager) - Woodward easYgen-2000 Series User Manual

3.2.11

Relay Outputs (LogicsManager)

General notes
Schematic and terminals
Terminal Description
Common N.O.
A B Form A
30 31 Relay output [R 01]
32 33 Relay output [R 02]
34 35 Relay output [R 03]
36 37 Relay output [R 04]
41 42 Relay output [R 06]
80 81 Relay output [R 07]
37535B
Setup Connections > Relay Outputs (LogicsManag...
Fig. 56: Discrete inputs - state N.C.
In the state N.C., a potential is continuously present during normal
operation; if an alarm is issued or control operation is performed,
the input is de-energized.
The N.O. or N.C. contacts may be connected to the signal terminal
as well as to the ground terminal of the discrete input (
matic and terminal assignment" on page 70 ).
CAUTION!
The relay output "Ready for operation" must be wired
in series with an emergency stop function. This means
that it must be ensured that the generator circuit
breaker is opened and the engine is stopped if this
relay output is deenergized.
– We recommend to signal this fault independently
from the unit if the availability of the plant is impor‐
tant.
For information on interference suppressing circuits
when connecting 24 V relays, please refer to
Ä Chapter 3.4 "Connecting 24 V Relays"
on page 83.
Fig. 57: Relay outputs - schematic
All
Fixed to "Ready for operation"
All
Preconfigured to "Horn"
All
Preconfigured to "Starter"
All
Preconfigured to "Fuel solenoid / gas valve"
Preconfigured to "Command: close GCB" or Logi‐
csManager
Preconfigured to "Command: open GCB"
easYgen-2200/2500 | Genset Control
1
1
1
1
1
Installation
Ä "Sche‐
A
max
2.5 mm²
2.5 mm²
2.5 mm²
2.5 mm²
1
2.5 mm²
2.5 mm²
71