Clamp Fastener Installation - Woodward easYgen-2000 Series User Manual

Genset control

Hide thumbs Also See for easYgen-2000 Series:

Table of Contents

Clamp Fastener Installation

Fig. 9: Remove terminals

Fig. 10: Insert screws in clamps

Fig. 11: Attach clamp inserts

Mount Unit (Plastic Housing) > Clamp Fastener Installation

For installation into a door panel with the fastening clamps, pro‐

ceed as follows:

Cut out the panel according to the dimensions in Fig. 8.

Don't drill the holes if you want to use the clamp

fasteners. If the holes are drilled into the panel,

the clamp fasteners cannot be used anymore!

Loosen the wire connection terminal screws on the back of

the unit and remove the wire connection terminal strip if

Insert the four clamping screws into the clamp inserts from

the shown side (Fig. 10; opposite the nut insert) until they are

almost flush. Do not completely insert the screws into the

clamp inserts.

Insert the unit into the panel cutout. Verify that the unit fits

correctly in the cutout. If the panel cutout is not big enough,

enlarge it accordingly.

Re-install the clamp inserts by tilting the insert to a 45° angle.

(Fig. 11/1) Insert the nose of the insert into the slot on the

side of the housing. (Fig. 11/2) Raise the clamp insert so that

it is parallel to the control panel.

easYgen-2200/2500 | Genset Control

Installation